产品设计：广东安规检测有限公司

设计标准：7006-53-1 E40灯头量规是广东安规根据标准IEC60061-3,GB/T1483.1的要求设计制作而成。

图中所示量规处于检验状态。当静止状态时，柱塞应凸出V面。

The gauge is shown in the test position. In the rest position the plunger shall be above plane V.

产品用途：

检验防意外接触性能。

To check protection against accidental contact.

使用方法：

如果灯完全插入量规时，W面没有凸出V面，则可认为灯的形状对于防意外接触性能是合格的。

The shape of the lamp with regard to protection against accidental contact is assumed to be correct if the test sample being pushed as far as possible into the gauge, plane W does not protrude beyond plane V.